7
7.11
3. Apply Loctite 603 retaining compound to the outer
circumference of the new bearing race and carefully
press the new bearing into the bearing carrier
housing.
NOTE
Use care to not allow any of the Loctite compound to
get in the bearing.
4. Wipe the housing clean of any excess compound and
install the snap ring.
INSTALLATION
1. Install the drive shaft axle through the backside of
the bearing carrier.
2. Install the upper and lower ball joint ends into the
bearing carrier.
3. Install new pinch bolts and fastener hardware.
Torque new pinch bolts to specification.
NOTE
Refer to the Polaris Electronic Parts Catalog for
replacement pinch bolts and fastener hardware.
TORQUE
Pinch Bolts:
17 ft. lbs (24 Nm) Plus 90 Degrees
4. Apply grease to drive shaft axle splines.
5. Install the front wheel hub assembly, cone washers,
and hand tighten the castle nut. Install washers with
domed side facing out toward the castle nut.
FINAL DRIVE
To Next Page
Loading...
