7
7.23
8. Remove the bolts and flange nuts retaining the lower
steering post assembly to the frame on each side.
9. Lift the lower steering post assembly from the front
gearcase and out from the vehicle.
10. Remove the vent line and the (4) bolts securing the
front gearcase to frame.
11. Lay the gearcase on its side and rotate it in the frame
so the input shaft is facing you.
12. Remove the gearcase from the front LH wheel well
area and carefully slide it between the upper and
lower A-arms.
FRONT GEARCASE INSTALLATION - EPS
MODELS
1. Install the gearcase between the A-arms as shown.
FINAL DRIVE
To Next Page
Loading...
