7
7.35
17. Remove the input shaft assembly from the main
gearcase.
18. Inspect the pinion gear (N) for chipped, broken, or
missing teeth. Inspect the input shaft bearing (P) for
signs of wear. The bearing can be replaced separate
from the input shaft.
NOTE
Refer to the “Electronic Parts Catalog” for individual
part availability. Most parts are to be replaced as an
assembly or as a complete kit.
GEARCASE ASSEMBLY
NOTE
Refer to the photos used in the “Gearcase Disassembly
/ Inspection” procedure when needed, while assembling
the front gearcase.
1. Thoroughly clean all gearcase components before
beginning reassembly.
2. Install new seals and O-rings as shown (included in
the Seal Repair Kit).
3. Apply assembly grease to the seal lips to prevent
from damaging the seals upon assembly.
4. Install the input shaft assembly.
5. Torque the input cover screws to specification.
TORQUE
Input Cover Screws:
8 ft. lbs (11 Nm)
6. Install the roll cage and rollers into the ring gear.
Insert the rollers as the roll cage is installed.
7. Hold the roll cage assembly in the ring gear and turn
it over to install the torsion spring.
FINAL DRIVE
To Next Page
Loading...
