7.36
8. Install the torsion spring by wrapping each leg of the
spring around the dowel pin on the ring gear.
9. Align the spring retainer dowel pin with the ring gear
dowel pin and install the retainer on top of the torsion
spring.
10. Check the action of the torsion spring by rotating in
both directions to ensure the spring and retainer are
installed properly.
11. Install the male (RH) output hub assembly into the
main gearcase.
NOTE
Take care not to damage the seal lip or seal spring
while installing the output hub.
12. Carefully install the ring gear and roll cage assembly
into the gearcase housing.
FINAL DRIVE
To Next Page
Loading...
