7
7.15
FRONT PROPSHAFT
REMOVAL
1. Locate front propshaft roll pin through the right front
wheel well. Position the vehicle for roll pin removal.
2. Use the Roll Pin Removal Tool (PN 2872608), to
drive out the roll pin from the front propshaft.
Roll Pin Removal Tool (PN 2872608)
3. Remove seat, upper RH side panel and RH footwell.
4. Pull shaft back towards the transmission to remove it
from the front gearcase input shaft, then pull it
forward to remove it from the transmission output
shaft.
INSTALLATION
1. Apply anti-seize compound to all splines. Slide
propshaft back onto the transmission output shaft,
then slide it up onto the front gearcase input shaft,
verify pin holes are aligned.
2. Using Roll Pin Tool (PN 2872608), install a NEW roll
pin (spring pin) into the propshaft.
3. Reinstall footwell, side panel and seat.
FINAL DRIVE
To Next Page
Loading...
