5.26
10.Press the shaft and bearing out of the outer sheave
using an arbor press.
11. Inspect the bearing
d
for wear. Spin the bearing, if
the bearing does not spin smoothly, replace it. To
replace the bearing, remove the snap ring
f
from the
end of the shaft and press the bearing off the shaft.
12.Inspect the cam (helix) assembly bushing
g
for wear.
If the bushing is worn or the shaft does not fit snug
into the bushing, replace the cam (helix) assembly.
13.Inspect the sheaves for excessive wear or damage.
DRIVEN CLUTCH ASSEMBLY
BEARING INSTALLATION
1. Install a new bearing
q
onto the clutch shaft using an
arbor press. Once bearing is fully seated, install a
new snap ring
w
.
2. Install the shaft and bearing assembly into the outer
sheave using an arbor press.
NOTE
Press only on the outer race of the bearing during
installation to prevent damaging the bearing.
PVT SYSTEM
To Next Page
Loading...
