5
5.25
3. Remove the four screws
w
that secure the cam
(helix) assembly using a T25 Torx driver.
4. Place the driven clutch into the Universal Clutch
Compressor.
Universal Clutch Compressor:
PU-50518-A
5. Press down on the top of the spider assembly,
pushing the spider onto the shaft. Remove snap ring
e
and slowly release the assembly.
6. Remove the spider assembly and spring.
NOTE
Spring is compression only and has no torsional wind.
7. Remove the E-clips, washers, and the clutch rollers.
Inspect the rollers for wear; replace if worn.
8. Press out the spring pins
o
in the inner sheave.
9. Pull out the clutch slider pins
a
and sliders
s
.
PVT SYSTEM
To Next Page
Loading...
