2
2.17
10. Locate oil filter
e
through the access hole in the
frame. Place shop towels beneath the oil filter. Using
oil filter wrench (PU-50105) turn oil filter
counterclockwise to remove it.
11. Use a clean dry towel to clean the filter sealing
surface on the crankcase.
12. Check to make sure the O-ring on the new oil filter is
in good condition. Lubricate O-ring on new filter with
a film of fresh engine oil.
13. Install new oil filter to specification.
TORQUE
Oil Filter:
Turn by hand until filter O-ring contacts sealing
surface, then turn an additional 3/4 turn.
14. Replace the guard plate.
15. Remove dipstick and fill engine with 2 qts. (1.9 l) of
the recommended engine oil.
FLUID CAPACITY
Recommended Engine Oil:
PS-4 Synthetic 4-Cycle Engine Oil
(PN 2876244) (Quart)
16. Start the engine and allow it to idle for one to two
minutes.
17. Stop the engine and check for leaks.
18. Re-check the oil level on the dipstick and add oil as
necessary to bring the level to the upper mark on the
dipstick.
19. Dispose of used oil and filter properly.
ENGINE BREATHER HOSE
Periodically inspect the engine breather hose
q
and
clamps. Be sure the breather hose is routed properly and
secured in place.
CAUTION
Make sure line is not kinked or pinched.
MAINTENANCE
To Next Page
Loading...
