7
7.51
3. Apply Loctite 603 retaining compound to the outer
circumference of the new bearing race and carefully
press the new bearing into the bearing carrier
housing.
NOTE
Use care to not allow any of the Loctite compound to
get in the bearing.
4. Wipe the housing clean of any excess compound and
install the snap ring.
BUSHING REPLACEMENT
1. Check bearing carrier bushings and shafts for
excessive wear or damage.
2. If replacement is required, slide shafts out and
remove the bushings with a drift punch.
3. Thoroughly clean the bearing carrier and inspect for
excessive wear or damage. Replace rear bearing
carrier if damaged.
4. Install new shafts and bushings. Press the bushings
into the bearing carrier until they are flush with the
mating surface.
5. Grease the rear bearing carrier fittings after it has
been installed and the rear A-arms have been
attached.
FINAL DRIVE
To Next Page
Loading...
