11.60
7. Install front half of the pod. Torque fasteners until fully
seated.
HEADLIGHT ADJUSTMENT, BUMPER
1. Place the vehicle on a level surface with the headlight
approximately 25 ft. (7.6 m) from a wall.
NOTE
Rider weight must be included on the seat while
performing this procedure.
2. Place the transmission in PARK.
3. Measure the distance from the floor to the center of
the headlight and make a mark on the wall at the
same height.
4. Start the engine and turn the headlight switch to high
beam.
5. Observe the headlight aim on the wall. The most
intense part of the headlight beam should be aimed 2
in. (5 cm) below the mark placed on the wall in Step
3.
6. Open the front rack.
7. Adjust the beam to desired position and tightening or
loosening the screws at the top of the lights. Adjust
each light independently.
WARNING
Due to the nature of ATVs and where they are
operated, headlight lenses become dirty. Frequent
washing is necessary to maintain lighting quality. Riding
with poor lighting can result in severe injury or death.
HEADLIGHT REPLACEMENT, BUMPER
Before replacing the lamp, use a digital multimeter to test
the harness to ensure the lamp is receiving 12 volts and
that a ground path is present.
1. Disconnect headlight lamp from the wiring harness.
Be sure to pull on the connector, not on the wiring.
2. Turn the lamp
q
counterclockwise to remove it.
3. Insert new the new lamp and turn it clockwise to
secure it. Reinstall the wire harness to the lamp.
NOTE
Make sure the tab on the lamp locates properly in the
housing.
ELECTRICAL
To Next Page
Loading...
