11.46
SWITCHES / CONTROLS
BRAKE SWITCH
Applying the brakes closes a switch to activate the brake
lamps. Use a multimeter to test for continuity when the
brakes are applied.
Replace the brake switch if function does not pass test.
IGNITION SWITCH
Use a multimeter to test for continuity between the 3
ignition switch outputs (OFF / ON / START). If any of the
tests fail, replace ignition switch assembly.
Turn the ignition key to ON. There should be continuity
between pins C and D; A and F.
Turn the ignition key to START. There should be
continuity between pins A and B; C and D.
IGNITION SWITCH - INTERNATIONAL
Use a multimeter to test for continuity between the 4
ignition switch outputs (OFF / ON, LIGHTS / ON /
START). If any of the tests fail, replace ignition switch
assembly.
Turn the ignition key to ON, LIGHTS. There should be
continuity between pins A, E and F; C and D.
Turn the ignition key to ON. There should be continuity
between pins C and D; E and F.
Turn the ignition key to START. There should be
continuity between pins A and B; C and D; E and F.
DRIVE MODE SWITCH
Use a multimeter to test for continuity between the two
switch outputs (ADC/AWD).
NOTE
Selecting 2x4 drive mode does not complete any
circuits. All circuits should be OL when 2x4 is selected.
Move the drive selector switch to each drive mode, and
then test for continuity.
ELECTRICAL
To Next Page
Loading...
