11
11.57
START SOLENOID RELAY
The start solenoid relay provides power to the following
system:
• Starter Motor Solenoid
COLOR FUNCTION
RD / WHT
20A circuit breaker-protected 12 Vdc
battery voltage.
BRN / WHT
ECM control for relay coil.
WHT / RD
Starter solenoid power.
BLU / YEL
Key-switched (START) relay coil power
12 Vdc battery voltage.
POWER STEERING RELAY (EPS MODELS)
NOTE
The power steering relay is not located inside the fuse
box.
The power steering relay provides power to the following
system:
• Power Steering Drive Motor
COLOR FUNCTION
ORG (85) or
(1)
LH RUN switch supplied 12 Vdc
battery voltage to relay coil.
BRN
Relay coil ground.
ORG (87) or
(5)
Power steering 12 Vdc battery power.
RD
30A fuse-protected 12 Vdc battery
voltage.
LOW BEAM RELAY
The low beam relay provides power to the low beam
lights.
COLOR FUNCTION
RD / BRN (1)
20A fuse-protected 12 Vdc battery
voltage.
DG (2)
Low LH control 12 Vdc battery voltage
to relay coil.
DG (4) Low beam lights power.
BRN (5) Ground for relay coil.
HIGH BEAM RELAY - INTERNATIONAL
MODELS
The high beam relay provides power to the high beam
light on international models only.
COLOR FUNCTION
RD / BRN (1)
20A fuse-protected 12 Vdc battery
voltage.
YEL (2)
High LH control 12 Vdc battery voltage
to relay coil.
RED (4) High beam lights power.
BRN (5) Ground for relay coil.
FUSE PROTECTED CIRCUITS
FUSE PROTECTED CIRCUITS
20A Fan Circuit
Breaker
Fan Motor
Starter Solenoid
10A Fuel Pump Fuel Pump
20A EFI
EFI Relay-controlled circuits:
-Ignition coil pack
-Fuel Injectors
10A Unswitched
Power
ECM
Fan Relay Driver
Ignition Switch
Instrument Cluster
Diagnostic Connector
30A EPS
Power Steering Relay / Motor
20A Lights
Head lights
Tail lights
Brake lights
20A Drive
AWD Coil
ADC Coil
RH AWD / ADC switch
Winch Switch Power
20A Accessory All accessory power point pigtails
10A Hazard
Not in Relay /
Fuse Box
Hazard and Flasher circuits
ELECTRICAL
To Next Page
Loading...
