7
7.37
13. Install the armature plate on top of the roll cage / ring
gear assembly. Be sure that the armature plate tabs
are fully engaged into the roll cage assembly and are
resting on the cut-out grooves of the ring gear.
NOTE
Install the female (LH) output hub assembly into the roll
cage / ring gear assembly.
14. Install the large O-ring onto the cover plate.
15. Lightly crimp the thrust pad to hold the pad on the
cover plate during installation.
16. Place the cover plate assembly on the main
gearcase and install the (6) screws. Torque screws
to specification.
NOTE
Take care not to damage the seal lip or seal spring
while installing the cover plate.
TORQUE
Cover Plate Screws:
8 ft. lbs (11 Nm)
NOTE
If the cover plate was replaced or if the backlash set
screw was repositioned, proceed to the “Setting Ring
Gear Backlash” procedure.
FINAL DRIVE
To Next Page
Loading...
