7.12
6. Install the brake caliper and torque the new mounting
bolts to specification.
TORQUE
Front Caliper Mounting Bolts:
37 ft. lbs (50 Nm)
CAUTION
New bolts have a pre-applied locking agent which is
destroyed upon removal. Always use new brake caliper
mounting bolts upon assembly.
7. Install the steering tie rod end onto the front bearing
carrier. Torque fastener to specification and install a
new cotter pin.
TORQUE
Tie Rod End Fastener:
42 ft. lbs (58 Nm)
8. Torque the wheel hub castle nut to specification and
install a NEW cotter pin. Tighten nut slightly if
necessary to align cotter pin holes.
TORQUE
Wheel Hub Castle Nut:
80 ft. lbs (108 Nm)
9. Install the front wheel and (4) wheel nuts. Torque
wheel nuts to specification.
TORQUE
Lug Nuts
Aluminum Wheels: 75 ft. lbs (102 Nm)
Steel Wheels: 45 ft. lbs (61 Nm)
10. Rotate wheel and check for smooth operation. Bend
both ends of cotter pin around end of spindle in
different directions.
FINAL DRIVE
To Next Page
Loading...
