6.14
4. If the bellcrank shift shaft was disassembled, install
the gear sector with the step facing the O-ring.
5. Install new O-rings on both shift shafts and lubricate
prior to installation.
6. Align the timing marks on the cam shift shaft and
bellcrank shift shaft.
7. Place the two shafts into the transmission as an
assembly.
NOTE
Gently rock or twist the shift shafts upon installation to
prevent from damaging the new O-rings. Forcing the
shift shafts straight into the transmission housing may
cut the O-rings.
8. Install the washer over the bellcrank shift shaft and
install the bellcrank by aligning the skip-tooth splines.
9. Install the retaining nut and torque to specification.
TORQUE
Bellcrank Retaining Nut:
15 ft. lbs (20 Nm)
10. Install the washer and a new retaining ring onto the
cam shift shaft. The retaining ring should be tight on
the shaft.
TRANSMISSION
To Next Page
Loading...
