6
6.17
31. Apply RTV silicone sealant to the outside edge of the
inner PVT cover to ensure a water tight fit between
the cover and the transmission.
32. Install the cover and torque the inner PVT cover
screws to specification.
TORQUE
Inner PVT Cover Screws:
5 ft. lbs (7 Nm)
33. Wipe away any excess silicone sealant.
34. Install the drive clutch, driven clutch and drive belt
(see Chapter 7 “PVT SYSTEM SERVICE -
Disassembly”).
TRANSMISSION
To Next Page
Loading...
