7.6
9. Install the lug nut for the corresponding new stud(s).
10.Using a calibrated torque wrench, torque lug nut to
specification to set the stud in the brake disc.
TORQUE
1st Torque Application:
5 ft-lbs (6.7 Nm)
NOTE
Failure to properly set the stud in the hub may damage
the knurling seat in the hub.
11. Without backing off the lug nut, continue to torque the
lug nut to specification to properly seat the stud in the
brake disc.
TORQUE
2nd Torque Application:
50 ft-lbs (68 Nm)
12.Without backing off the lug nut, continue to torque the
lug nut to specification.
TORQUE
3rd Torque Application:
75 ft-lbs (101 Nm)
13.Properly lower vehicle and verify proper operation.
FINAL DRIVE
To Next Page
Loading...
