8
8.15
8. Position the upper steering post on the shaft so the
pinch bolts are aligned with the recess in the power
steering shaft.
9. Install the pinch bolts and torque to specification.
Refer to “Steering Exploded View (EPS Models)”.
TORQUE
Upper / Lower Steering Post Pinch Bolts:
14 ft. lbs (19 Nm)
10.Torque the power steering mount plate fasteners to
specification. Refer to “Steering Exploded View (EPS
Models)”.
11. Install the fuel tank assembly, fuel line and reconnect
the fuel pump harness.
NOTE
There are two hidden upper mounting fasteners
12.Reinstall the upper steering post bushing bracket and
torque the (2) fasteners to specification.
TORQUE
Steering Post to Bulkhead Bolts:
18 ft. lbs (24 Nm)
13.Turn the ignition key to the “ON” position and move
the handlebar from left to right several times to
ensure the power steering doesn’t bind. If binding
occurs:
• Loosen the (4) mounting fasteners
• Move handlebars from left to right several times to
position the power steering unit
• Torque the (4) mounting fasteners to specification.
Refer to “Steering Exploded View (EPS Models)”.
See:
• Check the steering operation for binding again
• If no binding is present, proceed; if binding is still
present, repeat this procedure
14.Install the front cab.
15.Install the cover on front side of upper steering shaft.
16.Install the seat and side panels.
17.Install the fuel tank guards.
18.Connect both fans and install the radiator cover.
19.Install the six screws holding on the front cover.
20.Install the fan/snorkel cover (lock and ride fasteners)
STEERING / SUSPENSION
To Next Page
Loading...
