8
8.37
4. Refer to the assembly instructions for component
installation onto the shock asm.
Body/Bearing Cap
5. Use a small pick to remove seal from the body/
bearing cap.
6. Lubricate a new seal and fully install into body/
bearing cap.
7. Install the Shock Seal Protector Sleeve (2201639)
through the bearing cap seal to insure proper
installation.
8. Refer to the assembly instructions for component
installation onto the shock asm.
Bearing Assembly
9. Use a small pick to remove the U-cup seal (C),
internal (D) and external (E) O-rings from the bearing
assembly.
NOTE
If the bearing bushing requires replacement, replace
the bearing assembly.
10. Lubricate and install the O-rings and U-cup seal.
11. Push the Shock Seal Protector Sleeve (2201639)
through the bearing assembly O-ring and U-cup seal
to insure proper installation.
STEERING / SUSPENSION
To Next Page
Loading...
