8
8.39
9. Replace the o-ring on the piston valve and lubricate
with low temperature grease. Install the piston valve
as follows:
• This is the COMPRESSION side of the piston valve.
When installed, the compression side FACES the
compression valve stack.
• The bleed shim tabs are centered in the middle of the
compression ports.
• Note the orientation of the bleed shim tabs as the
assembly would be installed on the shock shaft.
10. Install the piston valve as shown in the photo. Install
the lock nut and torque to specification. Keep the
bleed shim tab aligned with the piston valve when
tightening the lock nut.
11. Install the rebound valve stack onto the shock shaft.
Tighten the lock nut to specification.
NOTE
Verify the bleed valve shim tab is orientated correctly
with the piston valve when tightening lock nut.
STEERING / SUSPENSION
To Next Page
Loading...
