3
3.19
4. Remove CPS, stator wire guide, and stator from the
cover.
5. Support the stator cover by the stator mounting boss,
using an aluminum or PVC pipe section or other
suitable support block (C) positioned inside the stator
housing as shown. Do not attempt to press water
pump shaft out of stator housing without first
supporting the cover by the stator boss, or cover may
be damaged.
6. Press shaft down until flush with end of mechanical
seal or until the seal spring starts to compress.
7. Select a suitable arbor (D) and press the shaft
through the seal until the shaft assembly is removed.
ENGINE / COOLING SYSTEM
To Next Page
Loading...
