Porsche Wallbox - General Requirements; Requirements and Conditions; Selecting the Installation Location

Requirements and conditions | GB
33
DANGER
Description Meaning
Local Wallbox
URL
URL to access the web app
PUK Personal unlocking key
Requirements and conditions
General requirements
Before assembly of the Porsche Wallbox, the follow-
ing requirements must be met and veried.
– The Wallbox must be installed by qualied per-
sonnel (electrician).
– Calculate the maximum electrical load of the in-
stallation to determine the maximum current the
Wallbox can draw.
– Minimise the voltage drop across the power line.
– Use copper lines to connect the Wallbox only.
– Make sure to obtain all approvals for the connec-
tion of the Wallbox.
– Verify the local regulations with a qualied elec-
trician and ensure that all applicable regulations
are complied with.
– Only use connectors and cables that comply
with local regulations, to ensure that the Wallbox
can be operated at the maximum possible cur-
rent.
– Protect the electrical connections with fuses.
Install a line circuit breaker and a fault current
breaker with a rated current sucient for the
maximum current occurring on the Wallbox.
Selecting the installation location
Electric shock, re
Incorrect use of the Wallbox or failure to observe the
safety instructions may cause short circuits, electric
shocks, explosions, re or burns.
e Do not install the Wallbox in a potentially explo-
sive atmosphere.
e Before installing the Wallbox, ensure that there
are no electrical lines in the area where the
mounting holes are to be drilled.
e To reduce the risk of explosion - particularly in
garages - make sure that the control unit is loca-
ted at least 39 in above ground while charging.
e Observe the locally applicable regulations for
electrical installations, re protection measures,
accident prevention regulations and escape
routes.
The Porsche Wallbox is designed for installation in-
doors and outdoors. The following criteria must be
considered when selecting a suitable installation lo-
cation:
– The Wallbox is intended for use in a xed loca-
tion only and must be mounted to a suciently
stable wall.
– Install the Wallbox in an area under a roof that is
protected from direct sunlight and precipitation
(e.g. inside a garage).
– Select the oor and ceiling clearance in accord-
ance with national standards and regulations to
ensure comfortable use.
– Select the distance from walls on either side so
that the vehicle charging cable can be plugged
in.