Pro-face ST Series - Initialize Internal Memory; Initialize ST Memory

Chapter 6 Initializing the ST
6-27
6.6 Initialize Internal Memory
This section explains how to initialize the ST's internal data.
6.6.1 Initialize ST Memory
This command erases all the ST screen data and initializes the ST's SRAM.
To initialize the ST internal memory, enter the common password 1101, or the password entered in the SYS-
TEM SET UP screen.
For details about entering password numeric values,
• You cannot cancel the Initialization procedure after pressing the Start key.
• AIl backed up data in SRAM is lost.
• Initialization does not erase the SYSTEM SET UP, the SIO protocol, or the inter-
nal clock settings.
SEE
5.3 Initialization (Page 5-5)
• The time required for Initialization is between 10 and 20 seconds.