Pro-face ST Series - St Edit Mode Peripherals

Chapter 1 Introduction
1-7
*1 For recommended units,
*2 Certain types and models of devices cannot be connected.
*3 This feature can only be used with Mitsubishi A, QnA and FX Series PLCs. For a list of compatible
units,
*4 For a list of compatible software,
*5 Certain types and models of PLCs cannot be connected.
*6 When the ST side of the cable uses a D-sub 25-pin connector, a 9pin <-> 25pin adaptor is required.
 ST Edit Mode Peripherals
*1 Certain type of PCs cannot be used.
SEE
Recommended Units (Page 1-8)
SEE
GP-PRO/PBIII for Windows Device/PLC Connection Manual (included with the screen editor
software)
SEE
GP-PRO/PBIII for Windows Device/PLC Connection Manual (included with the screen editor
software)
SEE
GP-PRO/PBIII for Windows Device/PLC Connection Manual (included with the screen editor
software)
SEE
GP-PRO/PBIII for Windows Operation Manual (included with the screen editor software)
SEE
GP-PRO/PBIII for Windows Device/PLC Connection Manual (included with the screen editor
software)
SEE
GP-PRO/PBIII for Windows Operation Manual (included with the screen editor software)
ST Unit
Data Transfer Cable
GPW-CB02
GPW-CB03
Personal
Computer*
1
GP-PRO/PBIII for
Windows Software
Edit Mode
F1
F1
F2
F2
F3
F3
F4
F4
F5
F5
F6
F6
Tool Connector