6
General Safety Precautions
About the Operation Environment
• Do not strike the touch panel with a hard or pointed object, or press on the touch panel with too much force, since it
may damage the touch panel or the display.
• Do not install the ST where the ambient temperature can exceed the allowed range. Doing so may cause the ST to mal-
function or shorten its operation life.
• Do not restrict or limit the ST’s naturally occurring rear-face ventilation, or store or use the ST in an environment that
is too hot.
• Do not use this unit in areas where large, sudden temperature changes can occur. These changes can cause condensa-
tion to form inside the unit., possibly causing the unit to malfunction.
• Do not allow water, liquids, metal or charged particles to enter inside the ST's case, since they can cause either a ST
malfunction or an electrical shock.
• Do not use or store the ST in direct sunlight, or in excessively dusty or dirty environments.
• Do not store or use the unit where strong jolting or excessive vibration can occur.
• Do not store or use the ST where chemicals (such as organic solvents, etc.) and acids can evaporate, or where chemi-
cals and acids are present in the air.
Corrosive chemicals:Acids, alkalines, liquids containing salt
Flammable chemicalsOrganic Solvents
• Do not use paint thinner or organic solvents to clean the ST, since they can cause either discoloration or a ST malfunc-
tion.
• Do not store or operate the LCD display in areas receiving direct sunlight, since the sun's UV rays may cause the LCD
display quality to deteriorate.
• Storing this unit in areas at a temperature lower than is recommended in this manual specifications may cause the LCD
display liquid to congeal, which may damage the panel. Conversely, if the storage area temperature becomes higher
than the allowed level, the LCD liquid will become isotropic, causing irreversible damage to the LCD. Therefore, be
sure to store the panel only in areas where temperatures are within those specified in this manual.
• Do not connect or disconnect the communication cable between the ST and the host during power-ups.
About the Screen Data
• Due to the possibility of unexpected accidents, be sure to back up the ST’s
screen data regularly.
To Next Page
Loading...
