137
• Short press: cruising speed will
increase by + 5 km/h.
• Long press: increase the vehicle
cruising speed continuously by step
of 1 km/h until the button is released.
• Press this button to resume cruising
at the set cruise speed from
previously set value before system
exit. (only available to vehicle with
ICC function).
3. Headway Increase button
Press this button briefly to increase the
cruise following distance (headway) in
ICC system (only available to vehicle
with ICC function).
4. Cancel button
Press this button briefly to cancel ICC
activation status (turn off to standby
mode) and to exit the ICC system.
5. ACC Speed Decrease button
• Short press: cruising speed will
decrease by - 5 km/h.
• Long press: decrease the vehicle
cruising speed continuously by step
of 1 km/h until the button is released.
6. Headway Decrease button
Press this button briefly to decrease the
cruise following distance (headway) in
ICC system (only available to vehicle
with ICC function).
Function Activation
To activate ICC, the following conditions
must be met at least:
• ICC system has been selected in
multimedia display screen and enabled
via OK button.
• The gear is in Drive (D) position.
• All doors, tailgate (trunk) and hood are
closed.
• The vehicle is in motion, and the brake
pedal is not applied.
• Brake system has no failure.
• Front camera has no problems, such as
high temperature, dirt or failure.
• Electronic Stability Control (ESC) system
is active.
• Electric Parking Brake (EPB) is released.
• The driver fastens the seat belt.
• Hill Descent Control (HDC) is turned off.
ICC Activation (vehicle is stationary)
When the vehicle is stationary, activate the
ICC system as follows:
• Select Intelligent Cruise Control (ICC) in
multimedia display screen. Then, press
the OK button to turn on (enable) ACC
system. The longitudinal and lateral
control indicator light for the cruise
system on the meter instrument display
will turn on in grey.
• Press the brake pedal or activate AUTO
HOLD function.
• Press the ICC speed increase and
resume button to activate ICC. At this
time, the set cruise speed is 30 km/h, the
set cruise speed on the meter instrument
display will illuminate in grey or green.
The cruise system longitudinal control
indicator on the meter instrument display
will turn to green.
• When the brake pedal is released, ICC
can continue to keep the vehicle
stationary.
• Press the ICC speed increase and
resume button again or press the
Driving Assist
To Next Page
Loading...