PULSAR MEASUREMENT
35
Page 3 – Data logging Information
This shows up to date logging information of all measurement information.
It also shows the sample interval that is currently set.
Page 4 – Trace logging Information
Trace logging is enabled by default, it can be disabled in program mode, if
not required. Echo traces are logged to the SD card, where the file and
format are TyymmddA and TyymmddA.DAT. Where ‘T’ indicates a trace
file/folder, yymmdd are the year, month, and day the file and folder were
created, and ‘A’ is a letter, starting with ‘A’ in case more than one file is
created in a day. A new log file will be generated each day for that month.
The .DAT suffix indicates that the files have been saved in such a way that
they can be viewed using PC Suite (Ultra PC).
The display shows whether the trace logging is enabled. The normal
interval is how often a trace is written/saved to the SD card, the fault
interval is how often a trace is written/saved to the SD card when a fault
occurs. The rest of the display shows settings for fault conditions, some of
which are referenced to user-set limits.
Page 5 – Pump Diagnostics
This page is always visible, but it is only populated when pumps are
programmed into the unit. The screen shows the following:
• Duty – The pump duty set for each pump e.g., ADB.
• SP1, SP2 & SP3 - The three setpoints associated with pumps.
• Closures – This is the number of closures for each relay.
• Status – Pump status, on or off. Off is shown in normal text where as
On is in inverse text.
• Run – Total run times (in hours) since the relay was configured.
• Current level.
Page 6 – Event Log
This screen shows the date and time of the occurrence of various events,
which are also written/saved to the SD card. The latest 9 events are
displayed on the screen.
The event log file and formats are EyymmddA.CSV, where ‘E’ is for event,
yymmdd are the year, month, and the day on which the file was created.
And ‘A’ is a letter starting at A in case there is more than one file started on
the same day. A new log file will be generated each day for that month.
To Next Page
Loading...
Need help?
General
