ULTRA 4 INSTRUCTION MANUAL
36
Page 7 – RS232 settings and Comms settings
Information regarding the RS232 and comms settings are shown on this
screen. The RS232 baud rate, number of bits, parity and number of stop bits
for the RJ11 serial port is displayed. If the Ultra 4 has optional comms
protocols enabled, the screen will show the device address and any
associated bus parameters.
Page 8 – Point Settings
This page shows the settings for the measurement point:
• Transducer type.
• Mode, e.g., Volume.
• Material (liquid, solids, or closed tank).
• Empty level.
• Span.
• Fail Mode.
Page 9 – mA Out Settings
This page shows the information portraying the mA out:
• Range – Maximum range of the output.
• Mode – Measurement represented by the output.
• Low – Measured value indicated by the Low limit.
• High – Measured value indicated by the High Limit.
• Fail Mode – Output of current during a failed safe mode.
• Low Limit – Minimum output current.
• High Limit – Maximum output current.
Page 10 – 10-day totaliser log
• Displays date and flow totaliser information for the last ten days, the
first on the list is the most recent and the last one is the oldest. When
all 10 totaliser logs are full the oldest is pushed out and all totals
increment through to allow the new days to be registered.
Page 11 – Echo information
• Displays current information relating to H.A.L.L (Height Above Loss
Limit), Average noise, Peak Noise and Echo strength.
To Next Page
Loading...
Need help?
General
