Radwin 2000 D+ - Figure 14-1 Bulk Backup Setup; Figure 14-2 Add; Remove Site

RADWIN2000D+UserManual Release3.6.00 14‐2
BulkSoftwareBackup Chapter14
Figure14‐1:BulkBackupsetupwindow
ThedefaultsitesshownintheBulkBackuplistpanelbelongtothecurrentlyinstalled
link.ThelistmaybeemptyifyouarerunningtheRADWINManager“offline”.
2.TheBulkBackuplist titlebarhasthreebuttonsontherighthandside.
Figure14‐2:Add/Removesitebuttons
TheleftbuttonopensupaWindowsfiledialogtolocatealist oflocationstobackup.
ThelisthasthefollowingformatforSNMPv1:
<IPaddress>,<Read‐Onlycommunity>,<Read‐Writecommunity>
ForSNMPv3itis:
<IPaddress>,<Dummy>,<User_type><Password>
Forexample:
10.104.3.2,netman,admin,netwireless
10.104.3.4,netman,admin,netwireless
APtMPlistwillcontaintheHBSandregisteredHSUs.
Thecenterbuttonallowsyoutoaddasinglesite: