Radwin 2000 D+ - Figure 6-7 Link Air Interface Parameters - Dbs Enabled, Acs on by Default

RADWIN2000D+UserManual Release3.6.00 6‐17
AirInterface Chapter6
Figure6‐7:LinkAirInterfaceparameters‐DBSenabled,ACSonbydefault
Figure 6‐5toFigure 6‐7containasubsetoftheActivationAirInterfacesettings.Youmayonly
changetheOperatingchannelwithACSdisabled.
TheseparametersareautomaticallyinheritedbytheRT‐B(HSU)whenyouclickOK.
ThroughputMode
TheAdva ncedbuttonenablestochooseathroughputmode:
ThroughputModedetermineshowtheAdaptiveModulationmechanismworks.Maximum
Throughput(default)shouldbechosenifthroughputismoreimportantthanhigherdelay.
Conversely,ReducedLatencyminimizesdelayattheexpenseoflowerthroughput.
LinkID
Youmaychangethistoanyconvenientstring.AfteryouclickOK,RT‐B(HSU)willbe
immediatelyupdatedovertheairwithoutinterruptiontoservice.