Radwin 2000 D+ - Page 41

RADWIN2000D+UserManual Release3.6.00 5‐2
GettingStartedwiththeRADWINManager Chapter5
 ToinstalltheRADWINManagerapplication:
1.InserttheCDintotheCD/DVDdriveofyourcomputer.
2.TheCDopeningwindowappears:
3.ChooseInstallRADWINManagerandfollowtheon‐screeninstructionsofthe
installationwizardtocompletethesetupoftheRADWINManagerapplication.
Iftheinstallationprogramfailstostart,browsetoyourCD/DVDdrive,chosethe
setup.exeprogramandrunit.
5.2GettingStartedwiththeRADWINManager
5.2.1PreparationforFirstLog‐on
Assupplied,oneODUisfactorypre‐configuredasRT‐A(HBS)andthesecondasRT‐B(HSU).
 TostarttheRADWINManager:
1.ConnectthemanagingcomputertoPoELANportoftheRT‐A(HBS)/
2.Thedefault IPaddressonallnewradiosis10.0.0.120withsubnetmask,255.0.0.0.
SetyournetworkinterfacetoanavailableIPaddressonthatsubnet,say10.0.0.111.
Thisisthepreferredwayofloggingon.
3.CheckthatyouhaveconnectivitytotheODU.Youcandothisbyopeningupa
commandlinesession(Start|Runandthentype,cmd).Atthecommandprompt,
type