Radwin 2000 D+ - Page 53

RADWIN2000D+UserManual Release3.6.00 6‐1
Chapter6:LinkConfiguration
6.1ChapterContents
ThischapterisdividedintotwosectionscoveringthetwophasesofLinkconfiguration:
1. Linkestablishment:Initialsetup
2. Linkmaintenance:Finetuningandspecialfunctions
Linkestablishmentistypicallyaonce‐onlytask.Linkmaintenanceisrequiredforfine‐tuning
thelinkandconfigurationofspecialfeaturessuchasVLAN,QualityofServiceandmore.
6.2LinkEstablishment
6.2.1LinkConfigurationWorkflow
ThepreviouschaptershowedyouhowtologontotheRT‐A(HBS).
TheRT‐A(HBS)requiresactiv ation.TheODUwillcommencetransmittingandreceiving
packetsrelatedtolinkmanagementonly‐thatisnoservice.ActivationandDeactivationare
effectedquitesimplybyclickingatogglebutton.
AssumingthattheODUintended
asLinkRT‐B(HSU)ismountedalignedandpoweredup,it
willdiscovertheMasterODUestablishingalinkformanagementonly.AtthispointtheRT‐
B(HSU)maybemanagedovertheair.
HavingIdentifiedtheLinkRT‐B(HSU),thelattermustberegisteredtotheRT‐B(HSU)toenable

trafficbetweenthem,completingphase1.
Followingregistration,youcansetseparately,
• MIMOmode
• Transmissionratiobetweenuplinkanddownlink
• UplinkanddownlinkMaximumInformationRate(MIR)inMbps
• VLANparameters
• QualityofServiceparameters.
Inwhatfollows,weassumethatyouareloggedontoRT‐A(HBS)onIPaddressasshowninthe
previouschapter.Hereistheopeningsituation: