Recognition Systems HandKey II - Page 106

HandKey II Installation and Operation Manual
Page 106 Revision 2.0
65. Press to skip to Step 67, the Aux Out Control command.
– or –
66. To disable the output cleared by Valid Access option, press .
– or –
To enable the output cleared by Valid Access option, press .
67. The Aux Out Control option now appears on the display.
68. Return to Step 6 to set Aux Out Control parameters for another Output.
– or –
69. Press to exit command mode.
– or –
70. Press to step to the next command. If the Auxiliary Keypad has not been
configured to trigger an output, the next command is the Set Reader Mode
command; skip to the next section. If the Auxiliary Keypad has been configured to
trigger an output, the next command is the Aux Kpd Use TZ command. The
current Aux Kpd Use TZ value appears on the display.
71. Press if the time zone assigned to the user should be applied when the user’s
ID number is entered at the Auxiliary Keypad. This means that to activate the
output, the time zone assigned to the user must be valid.
– or –
72. Press if the time zone assigned to the user should not be applied when the
user’s ID number is entered at the Auxiliary Keypad. This means that the output
will be activated regardless of the time zone assigned to the user.
73. Aux Out Control option now appears on the display.
ENTER
*
#
AUX OUT CONTROL
AUX 0/1/2?
5
*
AUX KPD USE TZ
(Y#) ?:
#
*
AUX OUT CONTROL
AUX 0/1/2?