Recognition Systems HandKey II - Page 105

HandKey II Installation and Operation Manual
Revision 2.0 Page 105
58. Press to skip to Step 61, the Aux Cleared by Timer option.
– or –
59. Press to assign the Aux Kpd to the output. The display shows the Aux Kpd
assignment.
60. Press to step to the Aux Cleared by Timer option.
61. The Aux Cleared by Timer option appears on the display.
The Aux Cleared by Timer option allows you to set a countdown timer value that will
automatically clear the output when the timer expires. The default value is 5 seconds.
This means that if an output is set and no valid access occurs within 5 seconds, the
output will automatically clear itself.
62. Press to skip to Step 64, the output cleared by Valid Access option.
– or –
63. To assign a Timer value, enter the digits for the number of seconds. For example,
for 20 seconds press .
64. The Valid Access option now appears on the display.
The Valid Access option allows you to determine if the output should be cleared when
a valid access occurs. The default value is Yes. This means that if an output is set and
a valid access occurs before the Aux Cleared by Timer expires, the output will
automatically clear itself.
AUX KPD
NO
ENTER
#
AUX KPD
YES
ENTER
AUX CLEARED BY:
TIMER (5)?:
NOTE
ENTER
2 0 ENTER
VALID ACCESS
(Y)?:
NOTE