Recognition Systems HandKey II - Page 99

HandKey II Installation and Operation Manual
Revision 2.0 Page 99
2. Press to exit the command menu.
– or –
3. Press to keep the current Auxiliary Output Control values and skip to the Set
Reader Mode command.
– or –
4. Press to Set the Auxiliary Output Control values.
5. The select Aux Out Control command appears on the display.
6. Press to select Output 0, press to select Output 1, or press to select
Output 2. The Aux Set by Time Zone option appears on the display.
7. Press to skip to Step 9, the Tamper option.
– or –
8. To assign a Time Zone to the output enter the digits for the time zone. For
example, for Time Zone 42 press .
9. The Tamper option now appears on the display.
10. Press to skip to Step 13, the TZ Violation option.
– or –
11. Press to assign Tamper to the output. The display shows the Tamper
assignment.
AUX OUT CONTROL
*NO YES#
5
*
#
AUX OUT CONTROL
AUX 0/1/2?
0 1 2
AUX. SET BY TIME
ZONE (##)?:
ENTER
4
2
ENTER
TAMPER
NO
ENTER
#