RDL-3000 User Manual
70-00158-01-DRAFT Proprietary Redline Communications © 2010 Page 100 of 142 November 25, 2010
5.3.8 generate
Use the generate command to generate a DSA key for use with SSH. The generated
key is saved in runtime memory and non volatile RAM.
Use the built-in utility to create SSH keys.
generate <sshkey>
The RDL-3000 will generate a key using its internal encryption engine.
sshkey <dsa | rsa>
dsa Generate DSA key for SSH.
rsa Generate RSA key for SSH.
Note: A system reboot is required to activate the new key.
5.3.9 get
Use the get command to view system parameters. Use the following general format to
view a parameter.
Display parameters.
get <parameter>
activeids
Number of active IDs (Services, Service Groups, and Links).
activelinks
Number of active Links.
dldpkt
Number of downlink discarded packets.
dloir <id>
Get the downlink offered information rate for the service.
dlrpkt
Number of downlink Rx packets.
dltpkt
Downlink Tx packets.
erxpkt
Number of Ethernet packets received.
erxpktd
Number of Ethernet packets received that were discarded.
ethsts
Speed and duplex settings for the Ethernet port.
etxpkt
Number of Ethernet packets transmitted.
grpoir <id>
Get the Offered Information Rate (OIR) for the specified service Group.
id Index value of the Service Group
idenable <id>
Check the status of a Link, Service Group, or Service.
To Next Page
Loading...
