Redline RDL-3000 - Logout

RDL-3000 User Manual
70-00158-01-DRAFT Proprietary Redline Communications © 2010 Page 104 of 142 November 25, 2010
5.3.11 logout
Use the logout command to terminate the current Telnet session.
Table 21: CLI - logout
End the current Telnet session.
logout
Terminate the current Telnet session (no parameters).
5.3.12 new
Use the new command to create a new Service Group, Service, or Link.
Table 22: CLI - new
Create a new Service Group, Service, or Link.
new <conn> <group> <link>
conn <id>
Create a new Service.
id - Specify a unique ID for this connection:
group <id>
Create a new Service Group.
id - Specify a unique ID for this Service Group:
link <id>
Create a new Link.
id - Specify a unique ID for this Link:
5.3.13 ping
Use the ping command to initiate an ICMP ping command from the RDL-3000.
Table 23: CLI - ping
Send an ICMP ping command. This can be used to confirm network access to FTP/TFTP
servers, syslog servers, etc.
ping <IP address> <Number of Packets>
IP address IP address of target.
Number of Packets Number of ICMP packets to send (1 to 16).
5.3.14 reboot
Use the reboot command to reboot the RDL-3000 firmware.
Table 24: CLI - reboot
Command the RDL-3000 to reboot. Entering 0 (zero) cancels reboot in-progress.
reboot <seconds>
seconds Number of seconds to wait before rebooting.
Note: Use this command in combination with Apply to temporarily test changes to the
configuration. For example:
set radio rf1 rf2 Modify desired parameter
reboot 600 Schedule reboot in 5 minutes
apply Activate configuration changes (without saving)
(5 min later) RDL-3000 reboots and loads saved configuration
5.3.15 reset
Use the reset command to zero the RDL-3000 statistics or ID table.