Redline RDL-3000 - Enable

RDL-3000 User Manual
70-00158-01-DRAFT Proprietary Redline Communications © 2010 Page 99 of 142 November 25, 2010
Table 15: CLI - del
usr User entered files (default if type is not specified).
factory Factory default files (requires hardware jumper selection).
fips FIPS mode files.
id <id>
Remove a Service Group, Service, or Link table entry.
id Unique number for Service Group, Service, or Link.
folder <usr | factory | fips>
Remove all files from the specified table.
usr - User entered files (default).
factory - Factory use only.
fip - FIPS mode files.
5.3.6 enable
Use the enable command to enable a specific ID (that was disabled).
Table 16: CLI - enable
Enable a Service Group, Service, or Link id.
enable <id>
Enable a specific ID.
id Unique number for Service Group, Service, or Link.
5.3.7 freq
Use the freq command to configure frequency ranges when using autoscan or DFS.
Table 17: CLI - freq
freq <add> <clearall> <del> <print> <reload>
add <begin> <end>
Add a frequency range (up to 32 ranges).
begin - start frequency (MHz)
end - end frequency (MHz)
clearall
Delete all entries from the frequency list.
del <idx>
Delete a frequency validation range
idx - Frequency validation range index. Use 'print' to display IDs.
print
Print the list of frequency ranges.
Local frequency ranges:
index begin end
-------------------------------
0 5810.0 5820.0
1 5830.0 5835.0
reload
Reload the active list of frequency validation ranges.