Redline RDL-3000 - Upgrade

RDL-3000 User Manual
70-00158-01-DRAFT Proprietary Redline Communications © 2010 Page 116 of 142 November 25, 2010
Table 31: CLI - snmptrap
identity v2: Enter associated SNMP community string.
v3: Enter account username for authorization.
change <idx> [-p <port>] [-i <ip_add>] [-c <community>] [-u username]
Modify the specified SNMP setting.
idx Index of the SNMP trap (use 'print' command to display ids).
-i <ip_add>] Enter destination IP address.
-p <port>] Enter destination port address.
-c <community> Enter associated SNMP community string (SNMP V1 or V2).
-u <username> Enter account username for authorization (SNMP V3 only).
clearall
Delete all SNMP parameters.
del <idx>
Delete the specified SNMP trap.
idx Index of the SNMP trap to be deleted (use 'print' command to display ids).
Linkupdown
Trap indicates when the wireless Link is lost and recovered.
Off -
On -
print
List all SNMP trap settings.
5.3.22 upgrade
Use the upgrade command to upload a new firmware binary file to the RDL-3000.
Table 32: CLI - upgrade
Configure SNMP community permissions.
upgrade <ip addr> <file name> <user name> <password>
ip addr
IP address of the FTP/TFTP server.
file name
Name of the binary file to be uploaded.
user name
FTP account name (FTP server only).
password
FTP account password (FTP server only).
TFTP: You must specify the TFTP server address and the full name of the binary file (including
.bin extension). The firmware binary file must be located in the default directory of the TFTP
server.
FTP: You must specify the FTP server address, account user name, account password, and the
full name of the binary file (including .bin extension). The firmware binary file must be located in
the default directory for the specified user account.