RDL-3000 User Manual
70-00158-01-DRAFT Proprietary Redline Communications © 2010 Page 71 of 142 November 25, 2010
Add Frequency Range
Begin: Enter the lower limit of the frequency scan interval (MHz). The scan interval
must be a subset of the region frequency range. The unit automatically compensates
for channel size when selecting the center frequency.
End: Enter the upper limit of the frequency scan interval (MHz). The scan interval
must be a subset of the region frequency range. The unit automatically compensates
for channel size when selecting the center frequency.
Add: Click to save the new range settings in the Local Frequency Range list. This
action does not check the validity of the specified range (see Test and Save buttons
at the bottom of the screen).
Delete Frequency Range
Index: Choose the index value of the scan interval to be deleted from local frequency
range table.
Delete: Click to permanently remove the selected (index) scan interval.
Local Frequency Ranges
These settings are saved in non-volatile memory and loaded when the unit is
rebooted.
Index: Index value of this entry in the local frequency range table.
Begin: Lower limit of the frequency scan interval (MHz).
End: Upper limit of the frequency scan interval (MHz).
Remote Frequency Ranges
If values have been downloaded, these settings is used when recovering from a loss
of registration. This list is not saved permanently, and is discarded when the unit is
rebooted.
Controls
Reload: Reload and display the saved (Local) scan intervals. Unsaved changes are
discarded.
Apply: Check the validity of the current range settings in the Local Frequency Range
list. All valid settings are activated.
Note: Click Save All in the main menu to save changes permanently.
To Next Page
Loading...
