RL78/F13, F14 CHAPTER 3 CPU ARCHITECTURE
R01UH0368EJ0210 Rev.2.10 110
Dec 10, 2015
5. The debugger uses the area FB300H to FB4FFH to store the result of tracing when the tracing function for
on-chip debugging is in use. Accordingly, use of this area is prohibited while the tracing function is in use.
6. The debugger uses the area FB500H to FB52FH as a working area when the hot plug-in function is in use or
when the DTC is in use for the real-time RAM monitor (RRM) or dynamic memory modification (DMM) function.
Accordingly, use of this area is prohibited while the hot plug-in function is in use or the DTC is in use for the
RRM or DMM function.
Caution When executing instructions from the RAM area, be sure to initialize the used RAM area + 10 bytes
with any desired value.
To Next Page
Loading...
Need help?
General
