RL78/F13, F14 CHAPTER 6 TIMER ARRAY UNIT
R01UH0368EJ0210 Rev.2.10 481
Dec 10, 2015
6.6.3 Cautions on Channel Output Operation
(1) Changing values set in the registers TOm, TOEm, TOLm, and TOMm during timer operation
Since the timer operations (operations of timer count register mn (TCRmn) and timer data register mn (TDRmn)) are
independent of the TOmn output circuit and changing the values set in timer output register m (TOm), timer output enable
register m (TOEm), timer output level register m (TOLm), and timer output mode register m (TOMm) does not affect the
timer operation, the values can be changed during timer operation. To output an expected waveform from the TOmn pin
by timer operation, however, set the TOm, TOEm, TOLm, and TOMm registers to the values stated in the register setting
example of each operation shown by 6.7 and 6.8.
When the values set to the TOEm, TOLm, and TOMm registers (but not the TOm register) are changed close to the
occurrence of the timer interrupt (INTTMmn) of each channel, the waveform output to the TOmn pin might differ, depending
on whether the values are changed immediately before or immediately after the timer interrupt (INTTMmn) occurs.
Remarks 1. m: Unit number (m = 0, 1), n: Channel number (n = 0 to 7)
2. Unit 1 is not provided in the Group A products.
Channels 7 to 4 of unit 1 are not provided in the Group B, C, and D products.
To Next Page
Loading...
