Renesas RL78/F13 User Manual

RL78/F13, F14 CHAPTER 8 TIMER RD
R01UH0368EJ0210 Rev.2.10 618
Dec 10, 2015
Perform the following for the timer mode (input capture and output compare functions).
When using the TRDGRCi (i = 0 or 1) register as the buffer register for the TRDGRAi register
 Set the IOC3 bit in the TRDIORCi register to 1 (general register or buffer register).
 Set the IOC2 bit in the TRDIORCi register to the same value as the IOA2 bit in the TRDIORAi register.
When using the TRDGRDi register as the buffer register for the TRDGRBi register
 Set the IOD3 bit in the TRDIORCi register to 1 (general register or buffer register).
 Set the IOD2 bit in the TRDIORCi register to the same value as the IOB2 bit in the TRDIORAi register.
In the input capture function, when the TRDGRCi register or TRDGRDi register is used as a buffer register, the IMFC
bit or IMFD bit in the TRDSRi register is set to 1 at the input edge of the TRDIOCi pin or TRDIODi pin.
When also using registers TRDGRCi and TRDGRDi as buffer registers for the output compare function, PWM
function, reset synchronous PWM mode, complementary PWM mode, and PWM3 mode, bits IMFC and IMFD in the
TRDSRi register are set to 1 by a compare match with the TRDi register.

Renesas RL78/F13 Specifications

General

Brand	Renesas
Model	RL78/F13
Category	Computer Hardware
Language	English