Ricoh A-C2 - Page 207

26 January, 2001 SERVICE PROGRAM MODE
5-33
Service
Tables
SP5 Mode Number Function and [Setting]
5812* 2* SMC Report Transfer Fax.
No.
Use this to input the fax number of the service
representative This number is printed on the
Counter Report (UP: System No. 19)
Press the
!
key to input a pause.
Press the “Clear modes” key to delete the
telephone number.
1 CSS Function On/Off
Japan Only
0: Off, 1: On.
5816*
2CE Call
Japan Only
0: Start, 1: Finish
5821* CSS PI Device Code
Selects the PI device code. DFU
[0~4 / 0 / 1 step]
5824 NVRAM Data Upload Uploads the UP and SP mode data (except for
counters and the serial number) from NVRAM on
the control board to a flash memory card. (☛
5.3.1)
While using this SP mode, always keep the front
cover open. This prevents a software module
accessing the NVRAM during the upload.
5825 NVRAM Data Download Downloads the content of a flash memory card to
the NVRAM on the control board. (☛ 5.3.2)
While using this SP mode, always keep the front
cover open. This prevents a software module
accessing the NVRAM during the download.
After executing this SP, switch the copier off and
on.
5828* 25* Software Switch Sets the reference for the network software.
[00000000~FFFFFFFFh / 00000000h / 1 hex unit step]
26*
Network Operation Mode
Setting
Sets the TCP operation mode for the network.
[00000000~FFFFFFFFh / 00000000h / 1 hex unit step]
27* Network Syslog Server
Address Setting
Sets the syslog server address for the network.
[00000000~FFFFFFFFh / 7F000001h / 1 hex unit step]
28* Network Time Server
Address Setting
Sets the time server address for the network.
[00000000~FFFFFFFFh / 00000000h / 1 hex unit step]
29* Network DNS Server
Address Setting
Sets the DNS server address for the network.
[00000000~FFFFFFFFh / 00000000h / 1 hex unit step]
30* Network Directprint Port
Number Setting
Sets the directprint port number for the network.
[1024~65535 / 9100 / 1 step]
31* Network IPP Timeout
Setting
Sets the IPP timeout for the network.
[30~65535 / 900 / 1 step]
32
Network IPX Address
Setting (NetWare)
Sets the IPX Address.
33*
Network Remote Printer
Number Setting
(NetWare)
Sets the remote printer number for the network.
[0~254 / 0 / 1 step]
34*
Network Software Switch
Setting (NetWare)
Sets the software switch for the network.
[0000~FFFFh / 0003h / 1 hex unit step]
35* Network Transport
Protocol of Print Server
Setting (NetWare)
Sets the transport protocol of print server for the
network.
0001h: TCP & IPX
0100h: TCP& IPX (Priority: IPX)
0102h: TCP Only (Priority: TCP)
0001h: IPX Only