8. Hot roller [D]
• The hot roller is easily damaged. Always handle it carefully.
9. C-rings x2 [E] (both ends)
10. Drive gear [F]
11. Bushings x2 [G] (both ends)
12. Pressure roller [H]
13. Fusing knob [I] ( x1)
14. Bushings x2 [J] (both ends)
• Before installing the new hot roller, peel off 3 cm (1 inch) from both ends of the protective sheet on
the new roller.
• Never touch the surface of the rollers.
• Work carefully to avoid damaging the surface of the hot roller.
• The standard pressure roller spring position is the upper position.
• When reinstalling the hot roller assembly and pressure roller assembly, make sure that the flange
position of the bushings is as shown.
Fusing Unit
119
To Next Page
Loading...
