065 Job Spool
Switches job spooling spooling on and off.
0: No spooling 1: Spooling enabled
066 HD Job Clear
This SP determines whether the job interrupted at power off is
resumed at the next power on. This SP operates only when
SP5828 065 is set to 1.
1: Resumes printing spooled jog.
0: Clears spooled job.
069 JobSpool Protocol
This SP determines whether job spooling is enabled or dis-
pabled for each protocol. This is a 8-bit setting.
0 LPR 4 BMLinks (Japan Only)
1 FTP (Not Used) 5 DIPRINT
2 IPP 6 Reserved (Not Used)
3 SMB 7 Reserved (Not Used)
090 TELNET
Disables or enables Telnet operation. If this SP is disabled, the
Telnet port is closed.
[0~1/1]
0: Disable
1: Enable
091 Web
Disables or enables the Web operation.
[0~1/1]
0: Disable
1: Enable
145 ActIPv6LinkLocal
This is the IPv6 local address referenced on the Ethernet or
wireless LAN (802.11b) in the format:
"Link-Local address" + "Prefix Length"
The IPv6 address consists of a total 128 bits configured in 8
blocks of 16 bits each. These notations can be abbreviated.
See "Note: IPV6 Addresses " below this table.
147 ActIPv6Sttles1
These SPs are the IPv6 stateless addresses (1 to 5) referenced
on the Ethernet or wireless LAN (802.11b) in the format:
"Stateless Address" + "Prefix Length"
149 ActIPv6Sttles2
151 ActIPv6Sttles3
Service Program Mode Tables
223
To Next Page
Loading...
