806x 4 Booklet
Number of jobs started in Booklet mode. If the machine is in staple mode, the Staple
counter also increments.
806x 5 Z-Fold
Number of jobs started In any mode other than the Booklet mode and set for folding
(Z-fold).
806x 6 Punch
Number of jobs started in Punch mode. When Punch is set for a print job, the P:
counter increments. (See SP8064 6.)
806x 7 Other Reserved. Not used.
8071
T:Jobs/PGS [0~9999999/ 0 / 1]
These SPs count the number of jobs broken down by the number of pages in the job, regardless
of which application was used.
8074
P:Jobs/PGS [0~9999999/ 0 / 1]
These SPs count and calculate the number of print jobs by size based on the number of pages
in the job.
8077
O:Jobs/PGS [0~9999999/ 0 / 1]
These SPs count and calculate the number of “Other” application jobs (Web Image Monitor,
Palm 2, etc.) by size based on the number of pages in the job.
807x 1 1 Page 807x 8 21~50 Pages
807x 2 2 Pages 807x 9 51~100 Pages
807x 3 3 Pages 807x 10 101~300 Pages
807x 4 4 Pages 807x 11 301~500 Pages
807x 5 5 Pages 807x 12 501~700 Pages
807x 6 6~10 Pages 807x 13 701~1000 Pages
807x 7 11~20 Pages 807x 14 1001~ Pages
• Interrupted jobs (paper jam, etc.) are counted, even though they do not finish.
• If a job is paused and re-started, it counts as one job.
• If the finisher runs out of staples during a print and staple job, then the job is counted at the time the
error occurs.
Service Program Mode Tables
249
To Next Page
Loading...
