Ricoh A2 - 8 Appendix; Troubleshooting; The RC Gate LED Display

8. Appendix
Troubleshooting
The RC Gate LED display
Indicates different patterns depending on the status of the RC Gate. For details, see the table below.
LED Pattern
6WDWXV
LED Pattern
6WDWXV
Power Off
The operating system is
starting up.
An application is starting up.
Registration to the
RS Center System
has not been completed.
Registration to the
RS Center System
has been completed and
communication is established.
The cable is disconnected
or broken.
The IP address has not been
assigned.
IEEE 802.1X authentication
server error.
Updating the system
firmware.
System error persists even
after restarting the device
for the specified number of
times.
Restarting
Shutting down
Communication error has
occurred.
Recovering from an error.
DJH012
* : Flashing at intervals of 1 second
* : Flashing at intervals of 0.2 second
105