You cannot check the overlaps of the discovery range before clicking the button and the
discovery range added by clicking the button.
The items that can be specified vary depending on whether [Network Search] or [Broadcast] is
specified. Click (Export data to a CSV file) to export the set search range as a CSV file.
4. Click (Save) when the setting is configured.
A discovery task is registered to the list. To immediately perform discovery, click (Immediately
perform).
• Select the discovery range that is already registered to the list area and edit the settings in the
property area. To save edited settings, click (Save).
• To delete a discovery range, select the discovery range to be deleted, and click (Delete).
• New devices may be added to the network. To find additional devices on the network after the
initial network configuration, perform discovery again.
• For details on the configuration items of each tab, see page 51 "Add Device".
Search the Device Again
This is the procedure for avoiding possible inconsistencies between the device information managed by
the RC Gate and the actual device information that may occur due to changing the IP address of the
device or other operation.
1. In the section area, click [Discovery & Polling].
2. Click [Manual Discovery] on the section tree.
• Click (Add) on the list area:
1. Specifying settings is possible when the half-bright highlighted setting item changes to
bright highlighted one.
2. To register a device, configure search conditions such as the IP address range, model
name, and status of the device.
• If a CSV file that specifies a search range is imported:
For details, see page 33 "Importing a CSV File".
• Auto Retrieve Router:
1. Click (Auto Retrieve Router).
2. Select [Number of Search Hops] and then configure the access account.
On the [Access Accounts] tab, you can specify all access accounts.
3. Click [Start Retrieval].
Automatic retrieval starts.
Searching for Devices
63
To Next Page
Loading...
