Ricoh A2 - 3. How to Configure and Check the Device; Screen Configuration

• In [Connect to @Remote System], enter the request number. If you click [Register], the remaining
initial system settings appear.
Permit @Remote Task Performance
You can specify whether or not to authorize the following @Remote tasks.
• Device Registration
• Auto Discovery
• Device Status Information Notification
• Device Counter Information Notification
• Device Service Call
• Device Manual Call/ Customer Call
• Device Alarm Call
• Device Supply Call
• Device Information Change Notification
• Device Firmware Updating
• Update System Firmware
• Device Registration from @Remote Center System
• Information Setting Request from @Remote Center System
• Information Retrieval Request from @Remote Center System
For details, see page 91 "Permit @Remote Task Performance".
Auto Discovery
Specify the auto discovery.
For details, see page 94 "Auto Discovery".
After configuration, click (Save).
SNMP Access
Specify the SNMP access.
For details, see page 57 "SNMP".
After configuration, click (Save).
Settings on Installation
25